The Solinette is a horizontal folder, i.e. the bed drops downwards on struts with the camera held horizontally, distinguishing it from the otherwise somewhat similar Kodak Retina. The top plate is almost symmetrical, with matching advance and rewind knobs, and the shutter release button on the right matching the bed release on the left.
The shutter is cocked manually. The release button is threaded for a cable release. There is a double-exposure prevention interlock, with no override control. The shutter is synchronized for flash, with a PC socket on top of the shutter unit, and a cold shoe on the top plate.
The lens focuses to 1m (3½ feet); focusing is by movement of the whole lens and shutter, with a focus ring behind the lens.
There is a mechanical frame counter in a window in the middle of the top plate, in front of the accessory shoe. This must be set manually when a new film is loaded; the counter is advanced to 'A' by pressing the button on the back of the top housing (as in the picture here; the button itself is released by a sliding control nearby). The camera back is then closed and the counter advanced to frame 1 by winding the film normally. The same button serves as the rewind release. On some examples, there is a film-type reminder dial in the rewind knob.
There were two versions of this camera: the Solinette and Solinette II, and the latter is far more common. Solinette II was sold in the US under the Ansco brand and called Ansco Regent. There were also several lens and shutter variations, as shown in the table below .
|Solinette Compur RMXV
|Solinette Prontor SV
|Solinette Prontor SVS
|Solinette Compur RMX
|Color Apotar f/3.5/45mm
|Solinette II Solinar
|Solinette II Prontor SVS
|Solinette II Apotar
The Solinette was replaced by the Silette, and the two were sold concurrently.
At sometime after 1958, the following the restyling of the Silette line, a rigid-body Solinette model was produced, as pictured here:
|Later rigid-bodied Solinette
image by mpclemens (Image rights)
- However, the double-exposure prevention interlock operates on the release button, so may be overridden by using the release lever on the shutter body itself. The shutter cannot be released without film in the camera, except by winding the sprocket-roller in the film chamber manually to disarm the interlock.
- Information obtained from the publication "Agfa Geschichte eines deutschen Weltunternehmens von 1867 bis 1997"
- When buying these cameras pay attention to the bellows which tears easily
- Focusing mechanism can be stuck, due to the soldification of the grease (Agfa-grease) and it needs a lot of work to fix