Difference between revisions of "Polaroid SX-70"

From Camera-wiki.org
Jump to: navigation, search
(Film issues)
(Film issues)
Line 47: Line 47:
 
'''Polaroid SX-70 Blend Film'''
 
'''Polaroid SX-70 Blend Film'''
  
In October 2006, a brand new SX-70 film was introduced. According to its producer, it uses an internal neutral-density filter and modified chemistry to yield vibrant colors, strong contrast, and high resolution. This professional-grade film is made by Polaroid in the Netherlands. As the cartridge is made to its original specifications and the ND filter is placed over the film and not the lens, it allows for full and normal use of all the camera's functions.
+
In October 2006, a brand new SX-70 film was introduced. According to its producer, it uses an internal neutral-density filter and modified chemistry to yield vibrant colors, strong contrast, and high resolution. This professional-grade film is made by Polaroid in the Netherlands. As the cartridge is made to its original specifications and the ND filter is placed over the film and not the lens, it allows for full and normal use of all the camera's functions.  The only disadvantage is that this film is not "manipulable" as was the original SX-70 film.  It's manipulable feature gave way to artistic creativity that altered prints to look like paintings.
  
 
The following are sample images shot with Polaroid SX-70 Blend film. They are courtesy of [http://www.lordofthelens.net Lord of the Lens], the North American distributor for SX-70 Blend.
 
The following are sample images shot with Polaroid SX-70 Blend film. They are courtesy of [http://www.lordofthelens.net Lord of the Lens], the North American distributor for SX-70 Blend.

Revision as of 04:21, 4 December 2007

The SX-70 was a folding single lens reflex Land Camera produced by the Polaroid Corporation in the 1970s. It was the first instant SLR in history, and the first camera to use Polaroid's new integral print film, which developed automatically without the need for intervention from the photographer - this was a revolution at the time, and a precursor to today's 600 and Spectra films.

The SX-70 utilized a folding body design, a 4-element 116mm F/8 glass lens, and an automatic exposure system. The lens could close focus to a distance of 10.4 inches, and had shutter speeds ranging from 1/175 to more than 10 seconds. There were a variety of models beginning in 1972 with the original SX-70, though all shared the same basic design. Later models were often equipped with a sonar autofocus system, and the Model 3 departed from the other models as it was not an SLR, instead using a viewfinder cut into the mirror hood - though all other mechanics were identical.

All models feature an electronically controlled 'flash-bar' socket across the top of the camera, for insertion of a 10-use set of flashbulbs. Polaroid - and other companies - also made external flash units that plugged into this socket.

As well as the folding SLR model, a variety of non-folding, 'consumer'-type models were released that also used to SX-70 integral film.


Accessories and Add-Ons

Though expensive, the SX-70 was popular in the 1970s and retains a cult following today. As such, many unique accessories were produced for the SX-70 including:

  • Telephoto lens - A teleconverter (pictured below) which gave an effective 1.5x conversion (to 174mm)
  • Close-Up kit - a set of macro-photography lenses coupled with flash adaptors/diffusers
  • Self-timer - a clockwork timer that clips onto the side of the unit, covering the shutter release button
  • External flash - Several models were made, including several by third parties.
  • Tripod Adaptor - Many earlier models of the SX-70 did not have tripod mounts built-in.

Image manipulation

One feature of the SX-70's integral print film is its ability to be manipulated while still developing. Because it is an instant film and develops over a period of several minutes, artists are able to "push" the emulsion material around the photograph to produce effects somewhat like impressionist paintings.

Film issues

Polaroid's SX-70 "Time-Zero" film was last produced in December, 2005, and was sold out of Polaroid inventory by March, 2006. There remains some film, now outdated, in the pipeline, which is being sold to artist/manipulators at exorbitant prices.

Other SX-70 users are left with five alternatives, four of which will allow the use of readily available, inexpensive 600/779 film in their cameras, and the fifth of which provides a private-labeled 600 variant that can be used as if it actually were the earlier film.

Polaroid 600 Film

First, some SX-70 owners modify their cameras to use Polaroid's more recent 600 film, which is readily available at retail photo shops and mass-merchandisers. SX-70 and 600 film packs are slightly different, however, as the 600 pack has some extra little 'nubs' at the front of the pack. Users must either use a playing card, an old photo or a dark slide from a used Polaroid film cartridge to help slide the 600 film into the camera....or just remove the nubs from the cartridge. This is very easy, but it's easier just to slide the pack in with a card underneath it; then remove the card.

The real problem with using common 600 or 779 film is that it is significantly faster than SX-70 film, causing serious overexposure by the old cameras. To address this issue, some simply set the exposure dial all the way to "darken" and replace the small Neutral Density filter over the electronic eye with a similar clear filter. Polaroid itself recommends placing a 1-stop ND filter over the lens, and replacing the small ND filter over the electronic eye with a clear piece of plastic (as from a CD case). But, even with these modifications, SX-70 users may find they still need to set the exposure controls fully to "darken."

Second, perhaps the most effective solution is to adapt the SX-70's exposure sensors and electronics to accept the current film's higher speed. A professional conversion of the camera can be obtained from a technician on the US West Coast, and possibly others. He adapts the electronics of the camera so that the light sensors and circuits will operate at the ASA 640 speed of the current film [as opposed to the ASA 150 sreed of the earlier film]. The benefit of this procedure is that the camera can take advantage of the far faster, modern film without the use of filters or other apparatus.

Third, It has been determined that a 28 mm, threaded, ND-4 filter, or a similarly-sized, quality glass 2-stop Neutral Density [ND-4] filter can be gently screwed into the barrel or placed over the lens of a folding SX-70, to "fool" the camera into believing that the 600 film inside is actually the ASA 150 film it was intended to use. This works quite well, and the cost for a good filter is between US$30 and $85. There is also a thin gel filter available, which is glued onto the front of the folding SX-70's lens. One of these typically costs about US$15, but it is far less durable than a good glass filter. The disadvantage of most glass filters is that [a] they must be removed in order to close the camera [and reinstalled for the next use], and [b] they darken the view through the SLR viewfinder to the extent that focusing is almost impossible for flash shots, and is very difficult in other low-light situations.

Fourth, there is a laminated film filter that can be slipped into the 600 film cartridge before it is installed into the camera. It is slid into the pack -- over the dark slide, but under the cartridge's edges. In use, it is directly in contact with the photo film, as was the dark slide, so that there is no space between it and the photo to permit light bending and distortion. The "PackFilter" is removable when the cartridge is empty, and can be used indefinitely. It is washable, in the event of too much handling, and the ND film is well protected with a special, heavy, durable polyester laminate on both sides. Even so, it is less than 10 mils thick [about like the dark slide]. It is also somewhat more than ND-4, since the 600 film is actually ASA 640 [more than two stops faster than TimeZero film], and the 30-year-old SX-70's have often slowed down a bit over time, increasing their tendency to overexpose. Another advantage is that they can be used in any camera intended for SX-70 film -- not just folding SX-70 SLR's. Their disadvantage is that they are easy to throw away with an exposed film cartridge.

Fifth, and finally, an Austrian company has contracted with the Polaroid film plant in the Netherlands to Private Label a variant of 600 film for them, using the old TimeZero film cartridge design, without the annoying "nubs". As described by its US distributor, below, it works beautifully, on the same basic principle as the PackFilter, above. Its only disadvantage is that is costs more than twice as much as 600 film purchased from any mass merchandiser.

Polaroid SX-70 Blend Film

In October 2006, a brand new SX-70 film was introduced. According to its producer, it uses an internal neutral-density filter and modified chemistry to yield vibrant colors, strong contrast, and high resolution. This professional-grade film is made by Polaroid in the Netherlands. As the cartridge is made to its original specifications and the ND filter is placed over the film and not the lens, it allows for full and normal use of all the camera's functions. The only disadvantage is that this film is not "manipulable" as was the original SX-70 film. It's manipulable feature gave way to artistic creativity that altered prints to look like paintings.

The following are sample images shot with Polaroid SX-70 Blend film. They are courtesy of Lord of the Lens, the North American distributor for SX-70 Blend.

343591142_2d5266c6c9_o.jpg

External links